******************************************************************* * RALINK TECHNOLOGY, CORP. * RALINK RT73 Wireless Card * SOFTWARE DRIVER RELEASE NOTE * ******************************************************************* [V 1.1.0.3] 1.) Support kernel 2.6.29. 2.) Fix DHCP Tx using high data rate ******************************************************************* [V 1.1.0.2] 1.) Support kernel 2.6.27. ******************************************************************* [V 1.1.0.1] 1.) Modify for kernel 2.6.24 and up. ******************************************************************* [V1.1.0.0] 1.) Use USB single write and new firmware to support USB single write. 2.) Support USB 1.1 and improve its throughput. 3.) Fix the bug: reboot AP,sta unload then load«á, excuting supplicant would crash. 4.) Fix the AdHoc problem with Connexant STA at A band. 5.) Fix the problem: can't link to Broadcom AP,when AP set auth:wpa2 cipher:aes 6.) Ap set 802.1x & Fragmentation set 256,station can't connect AP 7.) There are hidden AP in enviroment,sta connect to AP hardly. [V1.0.5.0] 1.) Fix the bug about deciding which BSSID is higher in IBSS mode. [V1.0.4.1] 1.) Support configuration by NetworkManager 2.) Support linux kernel version 2.6.21 ******************************************************************* [V1.0.4.0] 1.) Support big endian 2.) Support x64 platform 3.) Support ATE function 4.) Fix the rekey issue on WPA-Preshared 5.) Add A-band country region code #8(W53), #9(J52), #10 6.) Fix Long/Short Preamble setting 7.) Show mix mode in the results of site survey if any 8.) Driver sends disassociate event to WPA Supplicant when AP turns off 9.) Bug Fixed: compile failed on FC5 kernel more than 2.6.15 ******************************************************************* [V 1.0.3.0] 1.) Support WPA Supplicant 2.) Support fast roaming 3.) Support IEEE802.11H - radar detection 4.) RTS/CTS Rate set to 2Mb 5.) Add 11G Region #7 (Channel 5 ~ Channel 13) ******************************************************************* [V 1.0.2.0] 1.) Improve ping lost 2.) Support HW radio control 3.) Support roaming from an weaker AP to a strong AP 4.) Support Adhoc rates (11b only, 11b/11g mixed, 11g only and 11a only) 5.) Bug Fixed: Adhoc mode in WPANONE 6.) Bug Fixed: Can not work well with WEP encryption used the configuration file 7.) Verify process between RaConfig(utility) and rt73 dirver 8.) Support WPAPSK Both mode (TKIP+AES) 9.) Firmware version: 1.7 10.) Improve power saving mode ******************************************************************* [V 1.0.1.0] 1.) Prevent no error handling while reading profile and firmwave 2.) Bug fixed: an Ad-Hoc connection under corner case of incomplete scanning 3.) Bug fixed: AES shared group key 4.) Support Infra "11g only" 5.) Support Adhoc rates including 11b only and 11b/g mixed 6.) Support Asic Advanced Power Saving 7.) Short/Long slot time or Short/Long preamble follow by the capability of beacon 8.) Firmware version: 1.2 ******************************************************************* [V 1.0.0.0] 1.) Support little endian platform 2.) Support infrastructure and adhoc mode 3.) Supoort OPEN or SHARED or WPA-PSK or WPA2-PSK or WPA-NONE authentication method 4.) Supoort NONE, WEP, TKIP and AES encryption